THE PART
The part a machine consumed fastest.
Bucket teeth are wear parts — they are replaced, not repaired. A tooth taken at the end of its life carries the most concentrated record of work of anything on the machine.
THE TRANSFORMATION
The tooth keeps its adapter and its pin bore. The plinth is machined to the tooth, not the reverse, and the smoked plate sits directly on three bronze studs.
We take the part from a documented source and assess its condition.
We remove grease, loose corrosion and everything that does not belong to the future object.
We reinforce the structure, smooth the contact zones and design a stable base.
We keep the authentic patina, seal the steel and fit the glass.
We number the piece and issue the certificate of transformation.
MATERIAL MAP
- 01
Wear tip, taken at end of service life.
- 02
Pin bore, left open.
- 03
Octagonal plinth machined to the tooth.
- 04
Three bronze studs under the glass.
NUMBERING
Engraved steel plate, certificate of part origin and process, care card, and photographic documentation before and after transformation.
HA / TOOTH / 2026 / 001
DELIVERY & INSTALLATION
Because of the mass, quotation covers dedicated transport, carry-in and — depending on the model — on-site glass installation. Cost depends on location and access conditions.
